![]() ![]() Note: If you frequently switch between different versions of PHP, you may want to check out my Mac GUI, PHP Monitor. With Xdebug v3.0.0, Copyright (c) 2002-2020, by Derick Rethans $ pecl install xdebugĪfter running this command, running php -v should say: PHP 7.4.12 (cli) (built: 18:37:21) ( NTS ) Next up, we’ll want to make sure to install the latest version of Xdebug via pecl. That means we’re on the right track so far. With Zend OPcache v7.4.12, Copyright (c), by Zend Technologies Zend Engine v3.4.0, Copyright (c) Zend Technologies Paths referenced below might differ slightly if your Homebrew installation is located in /opt/homebrew. Note: If you are on an Apple Silicon-based Mac and you installed Homebrew without Rosetta, the Homebrew binaries can be found in /opt/homebrew/bin, as opposed to being located in /usr/local/bin. ![]() Let’s make sure php and pecl are installed and linked correctly.Īssuming you use Homebrew, your terminal output will be: $ which php Setting up Xdebugīefore we begin, I assume you have Laravel Valet installed. If you’re looking to set up a different environment (or would like to see a video), take a look here. Xdebug 3.0 has now been released, and some changes have been made to this guide to reflect this change. This is both for myself for future reference, and for anyone who stumbles upon this post and finds it helpful. After watching a stream where Matt Stauffer and Derick Rethans (the creator of Xdebug) discussed setting up Xdebug with Visual Studio Code, I decided it might be helpful to write a post on setting up Xdebug with PhpStorm, specifically if you’re running Laravel Valet.
0 Comments
Leave a Reply. |